Vaux Electronics Lattis 800 Series El manual del propietario

Lattis Matrix Switcher1600 and 800 Series Owner’s ManualPublication M-LE-00Manual Revision Jan. 1999Software Version 4.00Model Number:_______________S

Request-Command & Status-Message Summary:Status-Message are sent in response to above Control-Commands, but system status may also be determined

Command/Message Parameter Notes:zon is zone 0 to 255 (0=all) (or 1 to 255, depending on command) (no !S mssg returned for zon=0 cmds)src is audio/

mod is Zone Audio Mode 0=mono, 1=stereo, 3=spatial-stereo tud is Taper-Up-Delay 0 to 30 (ms/2-dB-step)tdd is Taper-Down-Delay 0 to 30 (ms/2-dB-

VC-232 Serial Port (EIA/RS-232)The VC-232 Port is designed to connect directly to any computer or control system which has a standard RS-232serial po

Maintenance and ServiceVaux systems are designed to be maintenance-free, but do contain sensitive electronic parts. Avoid rough treatmentto assure bes

Limited WarrantyWhat does your warranty cover?Any defect in material or workmanship.For how long after the original purchase?Three-year limited warran

Safety Information• As with any product, basic safety precautions should be observed during handling and use of this system.• Before using your system

For more information, visit our web site: www.vauxelectronics.comor email us: [email protected] Electronics, Inc.Arizona, USAPHONE: (480

INTRODUCTION... 4Matrix Switching and Zone

IntroductionThank you for selecting a Vaux Lattis Matrix Switcher. These systems have been designed for the utmost inperformance and reliability. The

Lattis Matrix Switcher Front PanelPower Switch Infrared Contol Sensor (below switch, left of logo)Power lightActive light (one or more zones on)Ack

Parts ChecklistWhen unpacking your Lattis system, ensure that you have received the following:• Lattis Matrix Switcher (LE-800A, LE-800AV, LE-1600A)•

RC-8-IR Remote ControlThe Vaux RC-8-IR Remote Control may be used to operate the Lattis Matrix Switcher. When the batteries are first installed, the

VauxProtocol Commands & Messages (RS-232)Connection of a computer or control system to the VC-232 serial port allows you to fully control the syst

Control-Command & Status-Message Summary:• For zones 1 to 255, Status-Messages are sent in response to Control-Commands.• Many commands return the